Leave Your Message
Operational Reliability Even In Case Of The Highest Ventilation Forces
FLENDER Gear Unit
Products Categories
Featured Products
SIEMENS SINAMICS V70 Low Voltage

SIEMENS SINAMICS V70 Low Voltage
SIEMENS SINAMICS V90

SIEMENS SINAMICS V90
SIEMENS SINAMICS G120C Low Voltage

SIEMENS SINAMICS G120C Low Voltage
SIEMENS SINAMICS G120 Low Voltage

SIEMENS SINAMICS G120 Low Voltage
SIEMENS SINAMICS G130/G150

SIEMENS SINAMICS G130/G150
SIEMENS SINAMICS S120 Low Voltage

SIEMENS SINAMICS S120 Low Voltage
SIEMENS SINAMICS S150 Low Voltage

SIEMENS SINAMICS S150 Low Voltage
SIEMENS SINAMICS S210 Low Voltage

SIEMENS SINAMICS S210 Low Voltage
SIEMENS Servo Motor Low Voltage

SIEMENS Servo Motor Low Voltage
SIEMENS Marine Motor Low Voltage

SIEMENS Marine Motor Low Voltage
01
9454376026142.jpg
9454376026142.jpg

Operational Reliability Even In Case Of The Highest Ventilation Forces

Wet Cooling Towers are those buildings where the water that was heated by industrial or power generation processes is cooled, again. The heat is given off to the environment. Wet cooling towers are an integral part of the thermodynamic circle. The water to be cooled is sprayed and distributed over the splash fills. As a result the water temperature drops when the evaporation heat is withdrawn and the air gets humified.

    Contact us
    product details

    description


    The required air stream for the cooling is produced by ventilators which are mounted on an output shaft of the gear unit. To enable the FLENDER Wet Cooling Tower Gear Units to absorb the enormous ventilation forces the gear units are equipped with an additional axial bearing. Therefore, only application-adapted 2-staged bevel helical gear units are used to fulfill the special requirements of this application.

    The motor is installed outside the cooling tower. He is mechanically connected to the gear unit that is placed right in the middle of the diffuser of the cooling tower via long Composite Couplings. These special couplings are also found in the FLENDER product range.

    Your benefits at a glance


    Low noise emission due to torsionally rigid housings
    Variable dimensions of the output bearings for the different ventilator types (according to the ventilating rail)
    Highest operational reliability due to one-part housings, reinforced bearings, centrifugal discs on the ventilator shaft
    Additional cooling realized by fan cooler on the input shaft
    Long service life as a result of optimized gear unit selection and use of high-grade materials
    Complete drive system from a single source

    Applications


    Power generating industries, like.:
    Biomass power plant
    Gas power plant
    Waste incineration plant
    Oil power plant

    contact